4000W PV hybrid system
01.
XTM Inverter chargers typically have a built in transfer switch that will sense when you are plugged into an AC source such as shore power or a generator. When AC is recognized by the inverter charger, the unit will act as a pass through, power your devices from the AC source and also charge the batteries if desired. When the inverter charger detects a loss of AC, the unit will switch over to invert or DC mode and power your devices off of the batteries that the power inverter has been charging.
True sine wave voltage
Excellent overload capabilities
Optimal battery protection
Adjustable integrated battery charger
Multistage programmable battery charger with PFC
Standby load detection adjustable over a wide range, starting from a low value
Automatic load detection
Parallel connectable
Best reliability
.Service 01
Can be used as a back-up system or uninterruptible power supply (UPS)
.Service 01
Multifunction contact
.Service 01
Adjustable power sharing
.Service 01
Reliable and noiseless with any kind of load
.Service 01
Support of sources of alternating current (Smart Boost)
.Service 01
Automatic support for peak loads (Power Shaving)
.Service 01
Ultra-fast transfer relay
.Service 01
High efficiency
.Service 01
Control by digital signal processor (DSP)
Electronic protection functions
• Deep discharge protection
• Battery overvoltage shutdown
• Short circuit protection
• Overtemperature and overload protection
• Reverse polarity protection by internal fuse (except Fangpusun Xtalent XTH 3000)
• Acoustic alarm at deep discharge or overheating
| Model | XTM 1500-12 | XTM 2000-12 | XTM 2400-24 | XTM 3500-24 | XTM 2600-48 | XTM 4000-48 |
| Characterisation of the operating performance | ||||||
| Nominal battery voltage | 12V | 12V | 24V | 24V | 48V | 48V |
| Input voltage range | 9.5-17VDC | 9.5-17VDC | 19-34VDC | 19-34VDC | 38-68VDC | 38-68VDC |
| Continuous power | 1500VA | 2000VA | 2000VA | 3000VA | 2000VA | 3500VA |
| Power 30 min. | 1500VA | 2000VA | 2400VA | 3500VA | 2600VA | 4000VA |
| Power 5 sec. | 3400VA | 4800VA | 6000VA | 900oVA | 6500VA | 10500VA |
| Max. efficiency | 93% | 93% | 94% | 94% | 96% | 96% |
| Own consumption stand by | 1.4W | 1.4W | 1.6W | 1.6W | 2.0W | 2.1W |
| Own consumption ON | 8.0W | 10W | 9W | 12W | 10w | 14W |
| Acoustic level without ventilation | 40 dB | |||||
| Acoustic level with ventilation | 45 dB | |||||
| Maximum load | Up to short-circuit | |||||
| Maximum asymmetric load | Up to Pcont. | |||||
| Load detection (stand-by) | 2 to 25 W | |||||
| Cos φ | 0.1-1 | |||||
| Output voltage | Pure sine wave 230Vac (±2%)/120Vac(1) | |||||
| Output frequency | 45Hz-60Hz(1)±0.05%(crystal controlled) | |||||
| Harmonic distortion | <2% | |||||
| Overload and short-circuit protection | Automatic disconnection with 3 time restart attempt | |||||
| Overheat protection | Warning before shut-off-with automatic restart | |||||
| Battery charger | ||||||
| Charge Characteristic | 6 steps: Bulk-Absorption-Floating-Equalization-reduced fl oating-periodic absorption Number of steps, thresholds,end current and times completely adjustable with the RCC-02/-03 | |||||
| Temperature compensation | With BTS-01 or BSP 500/1200 | |||||
| Power Factor Correction(PFC) according | EN 61000-3-2 | |||||
| Maximum charging current | 70A | 100A | 55A | 90A | 30A | 50A |
| Input voltage range | 150 to 265Vac/50 to 140Vac(1) | |||||
| Input frequency | 45 to 65Hz | |||||
| Input current max. (transfer relay)/Output current max. | 50Aac/56Aac | |||||
| Transfer time | <15ms | |||||
| Multifunction contacts | 2 independent contacts(potential free 3 points,16Aac/5Adc) | |||||
| Dimension h×w× [mm] | 133×322×466 | |||||
| Protection index | IP20 | |||||
| Operating temperature range | -20 to 55℃ | |||||
| Relative humidity in operation | 95% without condensation | |||||
| Ventilation | Forced from 55 | |||||
| Warranty | 5 years | |||||
| Weight | 15Kg | 18.5Kg | 16.2Kg | 21.2Kg | 16.2Kg | 22.9Kg |
Copyright © 2021 Wenzhou Xihe Electric Co., LTD| All Rights Reserved
